- New Launch Offer! Mini 35% Off On Products....
- Free shipping on orders above ₹ 1,000/-
:
:
:
0
0 items
₹0.00
No products in the cart.
L293D Motor Driver Servo Shield for Arduino (Green Connector)
In Stock
SKU:71485- 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer
- 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes.
- Can run motors on 4.5VDC to 25VDC.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution)
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping.
Digital Multi Servo Tester ESC Speed Control
In Stock
SKU:92038- Operating Voltage: DC 4.8-6V
- Offer 3 modes to check servos or ESC
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously
2WD Mini Round Double Deck Smart Robot Car Chassis DIY Kit
In Stock
SKU:50467- Smart car chassis tracing car Robot car chassis with code disk, Ideal for DIY.
- This car is the tachometer encoder.
- With a 4 AA battery box (batteries not included).
- It can be used for distance measurement, velocity.
- Can use with other devices to realize function of tracing, obstacle avoidance, distance testing, speed testing,
- Wireless remote control.
- Size: 21 x 15 cm (L x W).
- Wheel size: 6.5 x 2.7cm (Dia. x H).
Longer version of 4 WD Double Layer Smart Car Chassis Kit
In Stock
SKU:83756- Strong components so as to withstand extreme terrain conditions.
- Transparent Car Chassis.
- Attractive design.
PCA9685 16 Channel 12 Bit PWM Servo Motor Driver
In Stock
SKU:49528- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
65mm Rubber Tyre Wheel for BO Motors Red
In Stock
SKU:73912- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Green
In Stock
SKU:58614- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Blue
In Stock
SKU:46235- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Yellow
In Stock
SKU:71082- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Black
In Stock
SKU:54701- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
ULN2003A Driver Module Stepper Motor Driver Board
In Stock
SKU:86207- ULN2003A motor driver chip
- Chip all the pins already leads for easy connection to use
- 5-12V power supply
- 4-way signal indicator
- Step angle: 5.625 x 1 / 64
- Reduction ratio: 1 / 64
- Phase: 4
- Current / Phase: 5V
28BYJ-48 Stepper Motor
In Stock
SKU:71395- Rated voltage: 5V DC
- Reduction Ratio: 64:1
- Step Angle: 5.625° /64
- Frequency: 100Hz
- Self-positioning Torque: >34.3mN.m
- Friction torque: 600-1200 gf.cm
- Pull in torque: 300 gf.cm
200 RPM Dual Shaft BO Motor Straight
In Stock
SKU:45028- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
100 RPM Dual Shaft BO Motor Straight
In Stock
SKU:54692- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
60 RPM BO Motor L Shape
In Stock
SKU:62734- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
200 RPM BO Motor L Shape
In Stock
SKU:51860- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
Recently Viewed Products
TCRT 5000 Dual Channel Line Tracking Sensor Module
In Stock
SKU:32857- Operating Voltage: 3.5V-5V
- Supply Current: 15mA
- Optimal Sensing Distance: 3mm
- Designed with the reflected infrared sensor, indicator light.
- Built in a potentiometer for sensitivity control.
- On-board LM393 voltage comparator chip and infrared sensing probe TCRT5000L
- Signal detection sensitivity can adjust
- Reserve all the way more circuits (P3 voltage drawn)
Get our emails for info on new items, sales and much more.
Register now to get latest updates on promotions & coupons. Don’t worry, we not spam!


TechnoSam – Wired for Innovation. Built for Reliability.
At TechnoSam, we specialize in providing high-quality electronics modules, development boards, and IoT components for makers, developers, educators, and enterprises. Whether you’re building a prototype or scaling to production, our curated inventory and expert support help you bring your ideas to life — reliably and affordably.
Need Help?
(+91) 7030 10 3620
Monday – Friday: 10:00 AM – 05:00 PM
Saturady: 10:00 AM – 02:00 PM














