- New Launch Offer! Mini 35% Off On Products....
- Free shipping on orders above ₹ 1,000/-
:
:
:
0
0 items
₹0.00
No products in the cart.
L293D Motor Driver Servo Shield for Arduino (Green Connector)
In Stock
SKU:71485- 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer
- 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes.
- Can run motors on 4.5VDC to 25VDC.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution)
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping.
Digital Multi Servo Tester ESC Speed Control
In Stock
SKU:92038- Operating Voltage: DC 4.8-6V
- Offer 3 modes to check servos or ESC
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously
2WD Mini Round Double Deck Smart Robot Car Chassis DIY Kit
In Stock
SKU:50467- Smart car chassis tracing car Robot car chassis with code disk, Ideal for DIY.
- This car is the tachometer encoder.
- With a 4 AA battery box (batteries not included).
- It can be used for distance measurement, velocity.
- Can use with other devices to realize function of tracing, obstacle avoidance, distance testing, speed testing,
- Wireless remote control.
- Size: 21 x 15 cm (L x W).
- Wheel size: 6.5 x 2.7cm (Dia. x H).
Longer version of 4 WD Double Layer Smart Car Chassis Kit
In Stock
SKU:83756- Strong components so as to withstand extreme terrain conditions.
- Transparent Car Chassis.
- Attractive design.
PCA9685 16 Channel 12 Bit PWM Servo Motor Driver
In Stock
SKU:49528- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
65mm Rubber Tyre Wheel for BO Motors Red
In Stock
SKU:73912- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Green
In Stock
SKU:58614- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Blue
In Stock
SKU:46235- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Yellow
In Stock
SKU:71082- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
65mm Rubber Tyre Wheel for BO Motors Black
In Stock
SKU:54701- Tire with sponge liner for more strength
- With upgraded tire tread for greater friction
- New design wheel for better combination with the motor
- Diameter: 65 mm
- Width : 28 mm
- The material of Wheel: High-strength plastic
- The material of Tyre: Rubber
- Color: Black.
ULN2003A Driver Module Stepper Motor Driver Board
In Stock
SKU:86207- ULN2003A motor driver chip
- Chip all the pins already leads for easy connection to use
- 5-12V power supply
- 4-way signal indicator
- Step angle: 5.625 x 1 / 64
- Reduction ratio: 1 / 64
- Phase: 4
- Current / Phase: 5V
28BYJ-48 Stepper Motor
In Stock
SKU:71395- Rated voltage: 5V DC
- Reduction Ratio: 64:1
- Step Angle: 5.625° /64
- Frequency: 100Hz
- Self-positioning Torque: >34.3mN.m
- Friction torque: 600-1200 gf.cm
- Pull in torque: 300 gf.cm
200 RPM Dual Shaft BO Motor Straight
In Stock
SKU:45028- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
100 RPM Dual Shaft BO Motor Straight
In Stock
SKU:54692- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
60 RPM BO Motor L Shape
In Stock
SKU:62734- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
200 RPM BO Motor L Shape
In Stock
SKU:51860- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.35 Kgcm
Recently Viewed Products
DHT22 Temperature and Humidity Sensor Module AM2302
In Stock
SKU:61275- The module can detect the surrounding environment of the humidity and temperature
- High reliability and excellent long-term stability
- The output from the digital output
- Humidity measuring range: 20%~90%RH(0~50 degree (temperature compensation).
- Temperature measuring range: 0~+50degree.
- Humidity measurement accuracy: ±5.0%RH.
- Temperature measurement accuracy: ±2.0degree.
TTP229 16-Way Capacitive Touch Switch Digital keypad Module
In Stock
SKU:69327- Working voltage: 2.4V to 5.5V
- Built-in regulator
- Two modes
- Simple 8 key mode with independent 8 Channel parallel output.
- Advanced 16 Key modes with I2C interface output.
- Modes can be selected and configured by the user.
- Adjustable sensitivity
PLA Pro 3D Printer Filament (Virtual) – Brown
Out of stock
SKU:687654- Virtual Filament (Only for 3D Printer Subscription)
- Consistently High Quality and durable prints
- 10 times stronger than regular PLA on the market
- Deliver exceptional performance and printing smoothness
- Made from great, high-performance materials for professional prints
- Ready to print with any 3D Printer Subscription plan you take
Get our emails for info on new items, sales and much more.
Register now to get latest updates on promotions & coupons. Don’t worry, we not spam!


TechnoSam – Wired for Innovation. Built for Reliability.
At TechnoSam, we specialize in providing high-quality electronics modules, development boards, and IoT components for makers, developers, educators, and enterprises. Whether you’re building a prototype or scaling to production, our curated inventory and expert support help you bring your ideas to life — reliably and affordably.
Need Help?
(+91) 7030 10 3620
Monday – Friday: 10:00 AM – 05:00 PM
Saturady: 10:00 AM – 02:00 PM
















